Changing Of Diamonds - Sase PDG 9500+ Manual

Changing of Diamonds

Different applications often require different selections of diamond
tooling. There will be many occasions when the grinding discs need
to be changed.
Following is a guide for this procedure.
Preparation
Press the Stop button and engage the Emergency Stop button.
As an extra precaution, unplug power cord to prevent unintentional
starting of the machine while changing disc, which could result in
serious injury.
WARNING
It is highly recommended to have a set of gloves ready, as diamonds
can get very hot, especially during dry grinding applications.
Changing
1.
Set handle in upright position (Illustrated upper right).
2. Pull back on handle to lift grinding head off the ground (Illustrated
middle right).
3. Lay machine back on the ground (Illustrated bottom right)
4. Put on gloves.
5. Remove grinding disc from flex plate.
6. Check to ensure that all discs are secure.
7. Once new diamonds have been attached, reverse procedure to lower
machine to ground.
8. As new diamonds may be a different height than the set being previ-
ously used, re-adjust skirt to ensure good seal is established with the
floor.