To Resume A Cycle; Interrupting, Changing Or Canceling A Cycle; On/Off Button - Thermador DW44ZP Care And Use Manual

Thermador Dishwasher Model DW44Z

Interrupting, Changing or Canceling a Cycle

Cycle Interruption
As a safety feature the dishwasher will automatically
turn itself off whenever the door is opened. However,
if the door is opened quickly while in a wash or rinse
cycle some water may splash out of the dishwasher.
For this reason it is recommended that the machine
always be switched off before opening the door.
To Interrupt a Cycle
1. Press the on/off button to stop operation.
2. Wait at least 10 seconds (or until the water noises
stop) before opening the door.

To Resume a Cycle

1. Push the on/off button and close the door.
Changing a Cycle
To change the cycle selection, press the program but-
ton of the desired cycle TWICE. The chosen cycle
button (or the light above it) becomes illuminated,
showing that it has been selected.
Canceling a Cycle
1. Press the cancel drain buttons at the same time
and hold for approximately 3 seconds.
2. When the drain pump noises stop and the LED
display or clean light indicate that the end of the
cycle has been reached, the dishwasher is reset.
3. Press the on/off button to turn the dishwasher off.
4. The dishwasher is now ready to run a selected
cycle. Add more detergent if necessary.
DO NOT PULL DOOR FULLY
OPEN WHILE DISHWASHER IS
IN OPERATION.
OPENING THE DOOR WHILE
DISHWASHER IS IN OPERATION
COULD RESULT IN SERIOUS
SCALDING.

ON/OFF BUTTON

Figure 20
CHANGE CYCLE
Refill
Upper
Clean Rinse
Wash
Agent
Figure 21
CANCEL CYCLE
Refill
Upper
Clean
Rinse
Wash
Agent
Figure 22
Page 13
www.thermador.com
WARNING
QUICKLY
On
Off
Heavy Normal Light Rinse
Wash Wash Wash Only
• — Cancel Clean — •
Heavy Normal Light Rinse
Wash Wash Wash Only
• — Cancel Clean — •