Inserting/Replacing Batteries; Operation; Volume Control Buttons - PRONIVO SmartTRAK ST101 Manual

PREPARATIONS

Inserting/Replacing Batteries

Rechargeable or alkaline batteries are
suitable for use to power your locator.
Do not replace the batteries under wet or
rainy conditions. This may allow water to
enter the battery compartment.
Always replace all alkaline batteries at the
same time. Only use batteries from one
brand and with identical capacity.
Remove the batteries from the locator when
not using it for extended periods. When stor-
ing for extended periods, the batteries can
corrode and discharge themselves.

OPERATION

Power ON/OFF Button
8 once to power the locator ON.
Press
Pressing 8 once while the locator is on
will power the locator OFF. erase
erase
Sensitivity Control Buttons
MODE
The sensitivity or depth range can be varied
MODE
5 and
using the
observing the associated sensitivity adjust-
ment bar graph 2d. Pressing either button
will increment or decrement the sensitivity
to the next level and will be re ected in the
bar graph.
For example, pressing
raise the sensitivity to the next highest
level. The bar graph will display an addi-
tional bar.
VOL
VOL
6 buttons while
erase
erase
MODE
MODE
5 once will
erase
MODE
To Re move/Replace Batteries:
Unscr ew the thumb screw on the battery
cover and lift the cover off until the tab at
the rear of the cover clears the slot it is
located in.
Remove the batteries by raising the bat-
teries at the contact point of each pair.
Insert new batteries, observing the polarity
labels located inside the battery well.
Reinstall the cover in the reverse manner,
tightening the thumb screw on the battery
cover.
SENS VOL
SENS VOL
1-bar = lowest sensitivity
SENS VOL
6-bars = highest sensitivity
SENS VOL
The locator will remember and return to
the last sensitivity level selected the next
time it is powered ON. The optimal setting
is determined by the user for each particu-
lar application.

Volume Control Buttons

The volume can be varied using the
7 and 9 buttons, while observing the
erase
associated volume adjustment setting bar
MODE
graph 2e. There are ve volume levels.
Pressing either button will increment or
decrement the volume by one level.
- 20 -
MODE
STANDARD MODE
ERASE
STANDARD
SMART
ERASE
SMART
erase
MODE