General Safety Rules; Electrical Safety; Personal Safety - PRONIVO SmartTRAK ST101 Manual

GENERAL SAFETY RULES

Read all instructions. Working safely with this locator
is possible only when the operating and safety
information are read completely and the instructions
contained therein are strictly followed.
DO NOT remove or deface any warning/caution labels.
DO NOT use this locator for any purpose other than
those outlined in this manual. This could result in
serious injury or unsatisfactory performance.
DO NOT disassemble the locator. There are no
user serviceable parts inside. Do not modify the
product in any way.

Electrical safety

Batteries can explode or leak, cause injury or fire. To
reduce this risk, always follow all instructions and
warnings on the battery label and package.
Remove the batteries from the locator when not
using it for extended periods. When storing for
extended periods, the batteries can corrode and
discharge themselves.
DO NOT short any battery terminals.
DO NOT charge alkaline batteries.
DO NOT mix old and new batteries. Replace all old
batteries at the same time with new batteries of
the same brand and type.
DO NOT mix battery chemistries. Dispose of or
recycle batteries per local code.
DO NOT dispose of batteries in fire. Keep batteries
out of reach of children.

Personal safety

Do not use locator while you are tired or under
the in uence of drugs, alcohol or medication. A
moment of inattention while operating locator
may result in serious personal injury or incorrect
measurement results.
Use caution when using locators in the vicinity of
electrical hazards.
Store locator out of the reach of children and do
not allow persons unfamiliar with the locator or
these instructions to operate the locator.
Use the locator in accordance with these
instructions and in the manner intended for the
particular type of locator.
Complies with FCC Rules: This equipment has been
tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide
reasonable protection against harmful interfer-
ence in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accor-
dance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an output on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
This Class B digital device complies with Canadian
ICES-003.
SAVE THESE INSTRUCTIONS.
- 11 -
Use and care