General Use - Clatronic HC 2847 Instruction Manual

Hide thumbs Also See for HC 2847:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 38
Купить в интернет-магазине http://clatronic-shop.com.ua
Push two of the supplied attachments on to the heating surfaces of the device. Please
note the guide mechanism. Then push the plate downwards until it locks in place.
Thick-toothed accessories:
Fine-toothed accessories:
Flat accessories:
Insert the plug in a duly installed 230V/50Hz socket.
The red LED lights up. After approximately 5 minutes the device is ready to use.
The device must be used only for dry hair.
• Take a strand of hair and pull it carefully downwards until it is taut.
• The remaining hair should be put up or fixed in place. Before the halves are pressed
together for approx. 5 seconds, we recommend that you ensure that the hair is positi-
oned correctly.
• Always begin at the base of the hair and move the device in the direction of the hair
tip.
• In order to produce a uniform appearance it is important that the next strands fall in
one line.
• To ensure that the waves are retained for a prolonged period we recommend that you
use only a coarse comb or your fingers.
GB
Leave the appliance to cool before changing the accessories!
Mount the accessories in pairs on the heating surfaces (2 for large hair waves, 2 for
small hair waves or 2 for smooth hair) to avoid damaging hair!
Please remove the mains plug after use. Leave it cool for a few minutes before putting it
away.
In order to achieve a pronounced crimping effect, please apply gel or hairspray before
using the device (it is possible that the hair will produce a little „steam" or „vapour" - but
this is normal).
40
-HC 2847.indd 40
Электрощипцы CLATRONIC HC 2847
NOTE:
WARNING!
CAUTION:
to make large waves in hair,
for greater hair volume.
to make small waves in hair
for smooth hair

General Use

Styling Tips
25.09.2009 14:39:15 Uh

Advertisement

Table of Contents
loading

Table of Contents