Safety Precautions For Movement - D-Link DGS-8010 Quick Installation Manual

Scope
This document will guide you through the basic
installation process of your new switch. It is
intended for users who have some experience
in installing and maintaining network hardware.
We assume the reader is familiar with the terms
and concepts of Ethernet networks.
Safety Precautions for
Movement
The DGS-8000 series of switches are large and
heavy. When you handle them, please observe
the following precautions:
- Turn off all power supplies and unplug all
power cables before you move the switch.
- Remove the power, fan and service modules
to reduce the weight of the chassis before
moving it over a large distance.
- At least two people are needed to move
the switch. Do not attempt to move the
switch by yourself.
- Keep your balance when moving the
switch and avoid injuring your legs, feet,
or wrists.
- Grasp the correct handles on both sides
of the rack. Do not grab the power system
handle, fan handle or the back-panel
handle. These handles are used to install
and remove corresponding parts, not to
bear the full weight of the switch.
- The full weight of the switch could be in
excess of 80 Kg, so take extreme care
when moving it.
- To correctly move the DGS-8010, refer
to Figure 2-1 below. For the DGS-8006,
refer to Figure 2-2. Note that these
images are just schematic diagrams -
remove the board cards when moving the
chassis, to avoid increasing the weight of
the chassis or damaging the board cards.
Figure 2-1 The correct way to
move the DGS-8010 switch
Figure 2-2 The correct way to
move the DGS-8006 switch
DGS-8000 Series Chassis-Based Switch  3