ABB 500 Series Builder's Manual page 16


10
Mounting methods and mounting details
7RU[ VFUHZ
Generally, all the screws included in delivered mounting kits are of Torx type
and a screwdriver of same type is needed (Tx10, Tx15, Tx20 and Tx25).
)OXVK PRXQWLQJ
All terminal sizes, 1/2, 3/4 and 1/1 of 19" and RHGS 6 cases, can be flush mounted.
Only a single case can be mounted in each cut-out on the cubicle panel,
4. IP54 class is not possible when mounting two cases side-by-side in one cut-out.
0RXQWLQJ NLW GHWDLOV
Consisting of:
• 4 fasteners and fixing screws,
• sealing strip, see C in figure 4
• an instruction sheet
2SWLRQDO VHDOLQJ VWULS
• an additional sealing strip, to achieve IP54 class
The sealing strip is mounted between the front and the case frame.
1RWH 2UGHULQJ LQIRUPDWLRQ
7R DFKLHYH ,3 FODVV SURWHFWLRQ DQ DGGLWLRQDO VHDOLQJ PXVW EH RUGHUHG ZKHQ RUGHULQJ
WKH UHOD\ WHUPLQDO 7KH RUGHULQJ QXPEHU IRU WKLV RSWLRQ LV 0.&   ,W LV IDFWRU\
PRXQWHG
7HUPLQDO GLPHQVLRQV DQG PRXQWLQJ
see B in figure 4
&KDSWHU 
DOWHUQDWLYHV
see A in figure