Advertisement
TIP!
FIRST, REMOVE PAINT FROM BOLT HOLES. Because the powder coat finish applied at the
factory also adheres to the inside of bolt holes, pushing a bolt through it during assembly may be difficult. Therefore, before connecting
parts, we recommend that you check to see that bolts slip easily through all holes. If they do not, carefully clear paint from holes in side
bars, ends and arms using a small knife.
SECOND, be certain that barrel nuts and bolts screw together easily BEFORE beginning assembly. Residue from the black finish may
cause some bolts to stick a bit, therefore use the two hex wrenches enclosed (one for each end of the barrel) and screw them together to
clear away extra paint.
Item
Description
No.
3A
Side bar w/4 through holes
3D
Back bar w 2 through & 2 tap
holes
7B
Grid bracket for bookshelf
8B
Grid 8" x 22' x 2" x 2"
9
Bookshelf end piece
18A
1/4" buttonhead 1/4 x 20 /1/4
18E
#6 Wood screw 1/2"
22
Bookshelf curved arm (long)
25A
Pot hook straight
25B
Pot hook angled
STEP 1: LAYOUT PARTS FOR BOOKSHELF
On a table lay out all parts as shown in the exploded view above.
STEP 2: CONNECT MAIN BOOKSHELF BODY PARTS
TIP!
It is easiest to attach the pot rack parts when you insert the barrel nut (28B) from the INSIDE of the pot rack body, then screw the
barrel bolt (28A) into 28B from the OUTSIDE.
Temporarily connect two Bookshelf ends (9) and the side bar(3A) by inserting a barrel nut and bolt (28A, 28B) through the top hole at each
of four corners. This is the front of the rack. This will cause body of pot rack to stand on edge. Be certain side bar (3A) is on the INSIDE
when connected.
IMPORTANT: At this time you will NOT connect back bar (3D) to the body. It will be attached when the pot rack is installed on the wall.
However, at this time screw two button head bolts (18A) into lower screw holes simply to cover them. These are decorative only and will
not be used as anchors.
How To Assemble Your Pot Rack
Qty
1
1
3
1
2
2
2
2
4
4
Item
Description
No.
28A
Barrel screw
28B
Barrel screw
29
Wood shelf
35
(L) bracket
Installation Hardware
19C
Buttonhead screw 1/4 x 20 x 2"
26A
5/32 hex wrench
30A
Wall screw
30B
Wall sleeve
27A
1/4" Toggle
Qty.
5
5
1
2
2
2
2
2
2
Advertisement
