RACK IT UP MPO Manual

Download this manual

Oval Pot Rack

Model MPO

IMPORTANT!

We are committed to the highest quality in the manufacture of this RACK IT UP! pot rack. The components of

each rack are carefully inspected before shipment.

However, in case there is a problem, PLEASE LET US HELP YOU FIRST. Do not return the item to where you

purchased it. First, call us and explain what is missing or wrong. We will do our best to help with any question or

problem you have—and as fast as possible.

Call us TOLL FREE 1 (877) 362-5863 and ask for customer service. Thank you!

TOOLS NEEDED

We provide all tools required for assembly: hex wrench, fastener hardware (nuts, bolts).

Note under attaching instructions on page 3 of this booklet, the list of tools you will need to provide.

RACK IT UP! 1 Year Limited Warranty

This product is warranted to be free of material defects for a period of five years from the date of purchase. Your exclusive

remedy is the repair or replacement of the defective product, and shall be subject to the following conditions: (1) You send

a notice of any defect to RACK IT UP! within the warranty period, and (2) You return the defective product, to RACK IT

UP!, 24 Colwell Street, Port Hadlock, WA 98339, postage prepaid, within 20 days following receiving a return authoriza-

tion number. (A return authorization number may be obtained from RACK IT UP! by calling the number at the bottom of

this booklet.) There are no other warranties expressed or implied. There are no warranties of merchantability or fitness for

a particular purpose. RACK IT UP! specifically disclaims any and all incidental or consequential damages arising out of

purchase, installation or use of this product.

Page 1 (1) You send a notice of any defect to RACK IT UP! within the warranty period, and (2) You return the defective product, to RACK IT UP!, 24 Colwell Street, Port Hadlock, WA 98339, postage prepaid, within 20 days following receiving a return authoriza- tion number.
Page 2 How To Assemble Your Pot Rack TIP! FIRST, REMOVE PAINT FROM BOLT HOLES. Because the powder coat finish applied at the factory also adheres to the inside of bolt holes, pushing a bolt through it during assembly may be difficult. There- fore, before connecting parts, we recommend that you check to see that bolts slip easily through all holes.
Page 3 STEP 3: INSTALL DRYWALL ANCHORS—DO NOT TEST TOGGLE! ONE TIME USE ONLY!!! RACK IT UP!’s drywall togglers eliminate the need to bolt your pot rack to a stud. The steel anchors are very strong and when installed in drywall each drywall anchor holds about 200 lbs. Two anchors hold about 400 lbs., many times the weight you will likely hang from your pot rack.
Page 4 Insert screw hook and tighten until flush, then stop. NOTE: If you are also installing Trim Ceiling Covers (a RACK IT UP accessory), see pack- age instructions before inserting and tightening bolt/hook. Toggler ® Independent Lab Results...