Philips MG7770 Manual page 4

- Always make smooth and gentle movements
and be sure the surface of the comb always
stays in contact with your skin.
- When too many hairs have accumulated on the
appliance, blow the hairs out before use, for
best trimming results.
Body combs
Attach a body comb to the full-size hair trimmer to
trim hairs below the neckline. The appliance comes
with 2 body combs. The hair length settings are
indicated on the combs. The settings correspond
to the remaining hair length after trimming.
Comb
Body comb
(green)
Body comb
(green)
1 Attach a body comb to the full-size hair
trimmer.
2 To trim in the most effective way, stretch the
skin with your free hand and move the comb
against the direction of hair growth (Fig. 16).
Make sure the surface of the comb always stays
in contact with the skin.
Attachments for use on head
Extra-wide hair trimmer
Use the extra-wide hair trimmer without a comb to
clip the hair on your head very close to the skin
(1/32in (0.5mm) or to contour the neckline and
area around the ears.
1 To contour the hairline around the ears, comb
the hair ends over the ears.
2 Tilt the appliance in such a way that only one
edge of the cutter blades touches the hair ends
when you shape the contours around the ears.
3 To contour the nape of the neck or sideburns,
turn the appliance and make downward strokes
(Fig. 17).
4 Move the appliance slowly and smoothly
following the natural hairline.
Hair combs
Attach a hair comb to the extra-wide hair trimmer
to evenly trim the hairs on your head. The
appliance comes with 4 hair combs. The hair length
settings are indicated on the combs. The settings
correspond to the remaining hair length after
trimming.
Comb
Hair comb
Hair comb
Hair comb
Hair comb
1 Attach a comb to the extra-wide hair trimmer.
2 Move the trimmer slowly over the crown from
different directions to achieve an even result.
Make sure the surface of the comb always stays
in contact with the skin.
-
Always move the trimmer against the
direction of hair growth (Fig. 18). Press
lightly.
-
Make overlapping passes over the head to
ensure that all hair that should be cut has
been cut.
Fading hair comb
Attach the fading hair combs to the extra-wide hair
trimmer to trim the hair around the ears with a
faded result. The appliance comes with 2 combs.
Use both combs to trim hair around both ears.
Choose a hair comb based on the preferred
trimming direction of back to front or front to back.
Always make sure that you hold the side of the
comb with the short teeth closest to your ear.
Comb
Fading hair
combs
1 Attach the comb to the extra-wide hair trimmer
to trim the hair around the ear. Then attach the
other comb to trim the hair around the other
ear.
2 Place the appliance on your hair at the back or
front of your ear, depending on the trimming
direction you prefer. Always make sure that the
side of the comb with the short teeth is closest
to your ear.
3 Move the trimmer slowly around the ear, while
holding it steady (Fig. 19). For best results, move
the trimmer against the direction of hair growth
(back to front).
Precision attachments for use on face
Precision trimmer
Use the precision trimmer to create fine lines and
contours around your facial style, close to the skin
(to a length of 1/32in./0.5mm).
1 Hold the precision trimming head perpendicular
to the skin and move the trimming head
upwards or downwards with gentle pressure
(Fig. 20).
Eyebrow comb
Use the full-size hair trimmer with the eyebrow
comb attached for tidying up eyebrows or
trimming sideburns to a length of 1/4in. (6mm).
1 Slowly move the trimmer against the hair
growth direction. Press lightly and make sure
that the surface of the comb always stays in
contact with the skin (Fig. 21).
Nose trimmer
Use the nose trimmer to trim your nose hair and
ear hair.
- Make sure nasal passages are clean. Make sure
outer ear channels are clean and free from wax.
- Do not insert the tip more than 3/16in./5mm.
- Always clean the attachment after each use.
Trimming nose hair
1 Gently move the tip in and out of nose while
turning it around to remove unwanted hairs
(Fig. 22).
inch
1/8in.
3/16in.
inch
5/32in.
3/8in.
15/32in.
21/32in.
inch
5/32in.-3/8in.
mm
3mm
5mm
mm
4mm
9mm
12mm
16mm
mm
4-9mm