Jøtul F 360 Series Installation And Operating Instructions Manual page 16

ENGLISH
Fig. 25
4. Place the gasket on the end of the flue pipe (fig. 25 A).
5. Mount the smoke outlet (fig. 25 B) on the end of the flue pipe
that is fitted with the gasket.
6. Mount the flue pipe and smoke outlet from the inside of the burn
chamber and attach the smoke outlet using M8x30 mm screws.
N.B. If the flue pipe is longer than 350 mm it has to be assembled
into the smoke outlet from the outside of the product.
7. Fasten the cover to the top outlet (fig. 3) with the screws that
fastened the smoke outlet.
N.B. It is important that the joints/flue pipes are completely
sealed. Air leaks can prevent the flue pipe from functioning
properly.
4.4 Mounting of the product
Fig. 26
1. Place the baffle plate with the bar in the groove on the ribs
(fig. 26 A).
2. Move the base plate through the opening and place it on
the bottom.
16
Fig. 27
3. Place the riddling grate in position on the base plate. Check
that the riddling grate's slot on the right side is entered into
the riddling bar (fig. 27 A).
4. Place the ash pan at the bottom of the product.
5. Place the rear burn plate in the base plate's rear groove.
6. Place the side burn plates (fig. 29 F) on each side in the base
plate's side grooves. Move the baffle plate in and place it so
that it rests on the side and rear burn plates.
7. Hold the baffle plate while the other side burn plate is
mounted.
8. Let the baffle plate rest on the burn plates