Morphy Richards Meno Instructions Manual page 5

CM47560MEE Rev1_9225 47507 MEE pump - Jon 11/03/2011 09:05 Page 5
g
Features
⁄ Lid
¤ Lid Lock
‹ Blending Rod
› Frothing Attachment
fi Circular Whisk
fl Jug
‡ Heat and Froth Button
· Froth Button
‚ Base
„ 360˚ Connector
‰ Cable Storage (underneath)
Before first use
Remove the protective cardboard between the base and jug.
Wash the inside of the Meno Milk Frother using warm soapy water
and a soft damp cloth. DO NOT use a scouring pad or abrasive
material as this will mark the stainless steel. Rinse and dry.
DO NOT IMMERSE IN WATER
Instructions for use
1. Place the Meno Milk Frother onto a dry, level surface.
2. Remove the lid by twisting anti clockwise and lifting upwards.
3. Ensure the Frothing Attachment › is fixed on to the Blending
Rod ‹. Screw it on by rotating it clockwise to tighten A.
4. Pour milk into the jug.
When using the Frothing Attachment with the Circular Whisk fi
use a minimum 150ml of milk, and a maximum of 300ml.
Do not exceed the max level indicator.
5. Put the lid back onto the jug by twisting clockwise into place. The
Milk Frother will not operate until the lid is locked into the handle
B.
6. Select the required programme – Heat and Froth ‡ or Froth ·.
To heat and froth
Press the Heat and Froth button ‡ on the jug. The button will
light up red and the programme will begin.
It takes approximately 3 minutes to heat and froth your milk,
heating your milk to a temperature of 65ºC. When heating and
frothing is complete, the milk frother will automatically switch off.
To stop mid cycle, press the Heat and Froth button once, there
will be an approximate 30 second wait time before the
programme can be restarted.
Note: After heating and frothing, let the Milk Frother cool down for
approximately 30 seconds and always clean before reusing.
To froth
Press the Froth button on the jug ·. The button will light up blue
and the programme will begin.
It takes approximately 2 minutes to froth your milk, when frothing
is complete, the milk frother will automatically switch off.
To stop mid cycle, press the Froth button once.
Always clean before reusing.
Pouring the milk
• To make the perfect frothy drink it is recommended that the froth
is separated from the milk.
• Use a spoon / spatula to retain the froth in the jug, pouring the
milk into your drink, adding the froth to the top of your drink
afterwards.
Flavoured milk drinks
Remove the lid by twisting anti clockwise and lifting upwards.
Ensure the Circular Whisk fi is removed from the Frothing
Attachment › C.
Pour milk into the jug. 150ml minimum capacity, 500ml maximum
capacity.
For one serving of flavoured milk, pour 25ml of syrup and 175ml
milk into the jug. For two servings, simply double the measures.
Put the lid back onto the jug by twisting clockwise into place. The
Milk Frother will not operate until the lid is locked.
Press the Froth button ·.
It takes approximately 2 minutes for your drink to be prepared;
when complete the milk frother will automatically switch off.
Hot chocolate
This product is limited to 65˚C so that milk is not burnt. Therefore
it can be used for hot chocolate if you are satisfied to drink it at
this temperature.
Follow the instructions for 'Flavoured milk drinks' but use the heat
and froth button ‡.
Cleaning and care
Always clean after every use.
Carefully remove the Frothing Attachment › from the Blending
Rod ‹ by unscrewing anti clockwise D.
Run the lid incorporating the Blending Rod, under warm water,
wipe with a soapy cloth and rinse.
Run the Frothing Attachment under warm water, wipe with a
soapy cloth and rinse.
Clean the outer surfaces of the jug and lid with a soft damp cloth.
In the case of heavy soiling, a mild cleaning agent can be used.
Clean the inside of the jug using hot water, a soft cloth, soap
solution and rinse well.
No parts of the Meno Milk Frother are dishwasher safe.
DO NOT SUBMERGE THE MILK FROTHER IN WATER
WARNING: Care must be taken when cleaning not to get the
electrical contacts on the lid or main body wet.
g
5