water & more Aquameter Installation And Operating Instructions Manual page 8

Resetting the filter capacity: (after water filter replacement)
Step Button
Filter capacity is depleted
„ Indicator flashes
RESET
Press and hold the "RESET" button for approx.  sec.
1
„ "RESET" appears in the display
2
Filter capacity is reset
12
Memory information:
It is possible to access the 5 most recent measurements.
The capacity in litres [L] and the time period [t] are displayed for each case.
Step Button
PROG.
Press and hold the "PROG" button for approx. 5 sec.
1
„ "1" flashes
The display indicates the quantity in litres and the time
2
period of the last measurement
Press the "RESET" button once
RESET

„ The quantity in litres and the time period of the
next-to-last measurement are indicated
Repeat step  to access the 5 most recent measure-
4
ments.
PROG.
Press the "PROG" button once
5
„ Indication of the current filter capacity
Special function:
The overall number of litres (from the beginning of the water+more Aquameter
installation) can also be read out.
Step Button
PROG.
Press and hold the "PROG" button for approx. 5 sec.
1
„ "1" flashes
Once again press and hold the "PROG" button for ap-
PROG.
prox. 5 sec.
2
„ The overall number of litres from the start of operation
of the Aquameter is indicated
PROG.
Press the "PROG" button once

„ Indication of the current filter capacity
7. Guarantee
Indicator
In the event of a fault during the guarantee period,
please contact your contracting partner.
8. Operator Duties
You have purchased a long-lasting and service-
friendly product.
However, every technical appliance requires regular
service work to maintain correct functioning.
Sensor unit:
Battery:
Indicator
Battery replacement:
Loosen the screws on
the cover (Phillips head
screwdriver)
Indicator
total
check daily for leaks
the battery must be replaced after
approx. 5 to 7 years. If the battery
must be replaced, this will be indi-
cated in the display with "BATT".
Remove the cover, fol-
lowed by the empty bat-
tery.
The data stored up until this time is not lost
when the battery is replaced.
!
1
Insert new battery
(CR2032) (press down-
wards)
Observe the polarity!
Then fasten the cov-
er to the housing using
the screw