water & more Aquameter Installation And Operating Instructions Manual page 7

5. Installation
Sensor unit:
For initial installation, first attach the filter head

(see Installation and Operating Instructions,
10 10
If a pre-installed filter system is already in place,

remove the hose on the exit side of the filter head
by loosening the nut.
Attention:
The water supply to the filter system must be disconnected.
For disassembly, use an appropriate tool (flat wrench, 19 mm).
Screw the sensor unit with the gasket included in delivery (placed in the nut)

directly to the filter head.
Note:
Observe the direction of flow (arrow)
For assembly, use an appropriate tool (flat wrench, 19 mm).
Fasten the hose with gasket (placed in the nut) to the exit side of the sensor
unit (observe the direction of the arrow).
Important:
Ensure that
the installed lengths of the Aquameter and the bending radius of the hoses

are adhered to!
the flow direction (indicated on the filter head) is adhered to!

the measuring unit is installed horizontally!

the appliance is not exposed to any mechanical strain!

sealing and connecting elements are only used if they are suitable for the

provided operating conditions!
the piping is braced in front of and behind the appliance!

the system is ventilated before the start of operation!

"bestmax" installation section)
Display:
Fastening options:
Double-sided adhesive tape: (not included in
delivery)
Fasten a 50 x 40 mm piece of adhesive tape to

the rear side of the display.
Fasten the display in the desired position.

Attention:
Fastening must take place on a surface that is free
from grease, dust and dirt.
Screw: (not included in delivery)
Recommendation
diameter 4 mm
6. Programming
Filter capacity setting:
Step Button
PROG.
Press the "PROG" button once
1
„ "PROG" flashes
RESET
Press the "RESET" button once
2
„ first digit on the right, "0", flashes
RESET
Set the desired value by pressing the "RESET" button.

„ For the digit "2", press two times
Press the "PROG" button once to switch to the next
PROG.
4
digit
„ first digit, "0", flashes
RESET
Set the desired value by pressing the "RESET" button.
5
„ For the digit "6", press six times
RESET
6
Repeat steps 4 and 5 until all digits have been set.
PROG.
Press the "PROG" button once
7
„ The filter capacity is set
Flat head screw, max. shaft
„
Indicator
11