Electrolux ERN1400AOW User Manual page 10

10 www.electrolux.com
Problem
Water flows on the floor.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction of
the arrows.
Possible cause
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' temper-
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
1
2
1
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if nec-
essary.
Make sure that there is cold
air circulation in the appli-
ance.
2. Replace the lamp with one of the
same power and shape, specifically
designed for household appliances.
(the maximum power is shown on the
light bulb cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light comes on.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.