Related Manuals for Kohler Mira Flight Freestanding Bath
Summary of Contents for Kohler Mira Flight Freestanding Bath
- Page 1 Mira Flight Freestanding Bath 6D034-00 Installation & User Guide These instructions must be left with the user 1367822-W2-A...
-
Page 2: Before You Begin
Before You Begin Caution! Mira Flight baths are very heavy. Get assistance when moving or lifting the bath. • Warning! Appropriate safety apparel eg. gloves and safety footwear must be worn. • Make sure that the item is installed by a competent installer. •... -
Page 3: Pack Contents
Pack Contents Leg Pack Elbow Adapter Waste Cover (32 mm) F li g h t F Achtung! Anschließend die Badewanne mit einer zusätzlichen Schutzabdeckung gegen re e herunterfallende Gegenstände schützen. s ta Mit dem Einbau des Produkts erkennen Sie dessen Qualität an. n d in Wir gewähren auf dieses Produkt für Material- und Verarbeitungsfehler eine Garantie von 10 Jahren. -
Page 4: Tools Required
Tools Required Preparation Install waste pipe before fitting bath & allow access for connection Roughing in area for waste pipe Clean, level and prepare the area for installation. Note: The bath is suitable for externally mounted brassware only. 1367822-W2-A... - Page 5 Waste Cover Overflow Cover 1367822-W2-A...
-
Page 6: Installation
Installation Roughing in area for waste pipe Place the unit in the exact position where it will be installed, then mark around the outline of the bath. 1367822-W2-A... - Page 7 Batten To allow the feet to be adjusted place the bath on wooden battens at the short edges. Carefully lower the bath onto the battens. (Ø 5.5 mm) Roughing in area for waste pipe Temporarily fit the back feet to the bath. Fully extend the feet and mark their position on the floor.
- Page 8 Using a clean blanket, cardboard, or similar protective surface (towel), carefully turn the unit so it is laying on the top deck. Apply a bead of silicone into the foot sockets then fit the feet into the sockets. 32 mm Remove and discard the 90°...
- Page 9 Flexible Waste Hose Waste Trap Turn the bath over and place it onto the wooden battens. Connect the flexible waste hose to the waste pipe. 1367822-W2-A...
- Page 10 4 mm Flexible Waste Hose Waste Trap Bath Edge Adjust the legs equally until they protrude beyond the bath skirt approximately 4 mm. Temporarily remove the battens and check the bath sits level on the floor. Note: The bath edge should not be in direct contact with the floor. 1367822-W2-A...
- Page 11 Refit the battens. Push the plug to seal the drain then add enough cold water to just cover the bottom of the bath. 1367822-W2-A...
- Page 12 Push the plug to unseal the drain and check the waste connections for any leaks. Check and seal any leaks, then refill the bath to half way and repeat the leak test. Drain the bath. Apply silicone into each foot locker and to the bottom of each foot. Remove the wooden battens and pull the bath forwards until the rear feet engage with the foot lockers.
- Page 13 Installation of the bath is now complete, install hot and cold supplies and fit brassware as required. Note: The bath is suitable for externally mounted brassware only. 1367822-W2-A...
- Page 14 Cleaning ☺ 1367822-W2-A...
-
Page 15: Spare Parts
Spare Parts 4.1842.278 Waste Cover 4.1842.271 Leg Pack (x4) 4.1842.272 Foot Locker (x2) 4.1842.296 4.1697.222 Elbow Adapter (32 mm) Leg Pack (x1) 4.1842.274 Threaded Waste 4. 1842.257 Adapter Overflow Cover 4.1842.273 Waste Trap 4.1842.306 Flexible Waste Hose 1367822-W2-A... -
Page 16: Customer Support
Mira is a registered trade mark of Kohler Mira Limited. The company reserves the right to alter product specifi cations without notice. 14648 © Kohler Mira Limited, April 2019 1367822-W2-A...