Troubleshooting; Fault Causes And Remedies - Silvercrest SKR 800 C3 Operating Instructions And Safety Instructions

Troubleshooting

This section contains important information about fault identification and rectifica-
tion. Follow the instructions to avoid hazards and damage.

Fault causes and remedies

The following table will help you to identify and rectify minor malfunctions:
Fault
There is nothing on
4
the display .
No sound.
Interference with the
radio reception.
The time, the date
and the station pre-
sets are reset after a
power failure.
■ 20 │ GB │ IE │ NI
Possible cause
The plug is not plugged in.
The mains socket is not
supplying power.
The display is switched off
automatically or manually.
The volume is set to mini-
mum.
The device is in clock/stand-
by mode.
The external playback
device is muted in AUX
operation.
The audio cable is incor-
rectly connected in AUX
operation.
The reception is weak.
There are no batteries in the
battery compartment
the batteries are empty.
The batteries have been in-
serted the wrong way round
in the battery compartment
d
.
Remedy
Insert the power plug into the socket.
Check the house mains fuse.
Press any button on the device.
Increase the volume using the
−VOLUME+ |
You can switch the device to radio
operation by pressing the
−VOLUME+ |
Un-mute the external playback
device.
Ensure that the audio cable is cor-
rectly connected to the AUX input
and the external playback device.
Try to improve the reception by
relocating the wire aerial
Press and hold the
q
button for around 2 seconds to
receive the station in mono.
Check that the batteries are suffi-
d
or ciently charged and replace them if
necessary.
Check whether the batteries have
been inserted the right way round in
the battery compartment
doing so, note the polarity signs in
the battery compartment
The time, the date and the station pre-
sets will need to be reprogrammed.
1
/FUNC. dial.
1 dial.
/FUNC.
5
i .
| ST/MO
d . When
d.
SKR 800 C3