Table of Contents
Advertisement
CHAPTER 2: INSTALLATION INSTRUCTIONS
2.2 INSTALLING THE TRANSMITTER OR RECEIVER
Install one or two Transmitter or Receiver units in the rackmounted dual tray.
STEP 1: Install one Transmitter or Receiver into either slot from the front. The transmitter or receiver is fully inserted when it hits
the stop feature of the dual tray.
NOTE: The blanking panel can be used if only installing one unit and can be secured from underneath using four of the M3 x 6 mm
countersunk screws (included).
STEP 2: If you are installing two Transmitters or Receivers, insert the second one in the open slot.
STEP 3: Lock the installed transmitter or receiver unit into position by "closing" the locking bracket. See Figure 2-5.
NOTE: To remove the Transmitter or Receiver unit, open the locking bracket by unfastening the thumb screw.
STEP 4: If further stability is required, secure from underneath using four of the M3 x 6 mm countersunk screws (included).
6
FIGURE 2-5. TRANSMITTERS OR RECEIVERS INSTALLED
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
Advertisement
Table of Contents
