Table of Contents
Advertisement
•
The door locks, the display shows the
indicator
.
•
When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the delay start before you press the
. To cancel the delay start:
•
Press
to pause.
•
Press
shows
•
Press
programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Press
.
The indicator flashes.
2. Change the options.
3. Press
again.
The programme continues.
CANCELLING A RUNNING PROGRAMME
1. Turn the programme knob to position
cancel the programme and to deactivate the
appliance.
2. Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR
CAUTION! If the temperature and
level of the water in the drum are too
high and the drum still rotates, you
cannot open the door.
While a programme or the delay start operates, the
appliance door is locked and the display shows the
indicator
.
Open the appliance door when the
programme or the delay start operates:
to set the appliance
until the display
'.
again to start the
to
1. Press
to pause the appliance.
2. Wait until the door lock indicator
3. Open the door.
4. Close the door and press again
The programme or delay start continues to operate.
AT THE END OF THE PROGRAMME
•
The appliance stops automatically.
•
The acoustic signal operates (if it is activated).
•
In the display
comes on.
•
The indicator of the
•
The door lock indicator
minutes, then goes off.
•
You can open the door.
•
Remove the laundry from the appliance. Make
sure that the drum is empty.
•
Close the water tap.
•
Turn the programme knob to position
deactivate the appliance.
•
Keep the door ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
•
The drum turns regularly to prevent the creases
in the laundry.
•
The door lock indicator
flashes. The door stays locked.
•
You must drain the water to open the door.
To drain the water:
1. Press
. The appliance drains the water and
spins.
2. When the programme is completed, the door
lock indicator
When it goes off, you can open the door.
3. Turn the programme knob to position
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
STAND-BY
Some minutes after the end of the washing
programme, if you do not deactivate the appliance,
the energy saving status activates.
The energy saving status decreases the energy
consumption when the appliance is on the stand
by.
•
All indicators and the display go off.
•
The indicator of the
goes off.
.
goes off.
flashes for a few
is on. The indicator
flashes for a few minutes.
flashes slowly
to
to
15
Advertisement
Table of Contents
