Adax SET User Manual page 25

No. Fault
Blue GSM lamp is
2
permanently OFF.
Power output cannot
3 be controlled with M
button.
No functions are
available, and all signal
4
lamps are permanently
ON.
ADAX SET does not react
5
to any commands.
Blue GSM signal lamp
6
flashes.
10 No SMS response
SMS response with
11 following content:
Temp: N/A
NOTE! If the problem is not solved by any of the suggestions in this
checklist, you should refer to authorised service personnel at you local
Possible cause
- Cannot find or cannot
identify SIM-card.
- Weak or no GSM signal.
- System ON/ OFF switch (7)
is in the OFF position.
- No external power supply.
- System ON/OFF switch (7) is
in OFF position.
- Caller-ID is not activated.
- SIM-card account is not
activated.
- Phone contract.
- ADAX SET not operating
optimally.
- Wrong usage.
- GSM signal lost.
- Power cut.
- Receiving/transmitting
information.
- Searching for GSM signal.
- Pay-as-you-go account
balance is empty.
- Inactive/deactivated
SIM-card.
- No GSM connection.
- Power supply disconnected.
- Incorrect SMS command.
SIM-card.
- Temperature sensor not
installed.
- Temperature sensor
incorrectly installed
Possible solution
- Deactivate PIN-code.
- SIM-card not correctly installed.
- Invalid SIM-card.
- Foreign SIM-card.
- Identify GSM signal.
- Put System ON/OFF switch in ON position.
- Check the external mains power supply.
- Put System ON/OFF switch in ON position.
- Activate caller-ID.
- Check SIM-card account.
- Contact your service provider.
- M2M contract must be validated for
both calls and SMS.
- Pay-as-you-go cards must be topped-up.
- Put System ON/OFF button in OFF
position,
remove and check SIM-card, and revert
to default settings.
- Check that correct command format
was typed.
- Check GSM signal.
- Check power supply.
- Wait.
- If your mobile phone also displays a poor
network signal, it may help to move
ADAX SET to another position.
Top-up account balance.
Contact your service provider.
Check power supply.
Check SMS command – see user guide.
If using an old SIM-card with information
stored in its memory, deleting this
information may help.
Check that temperature sensor is attached.
Check that temperature sensor is pushed
fully in place.
GB 25