Table of Contents
Advertisement
HOW TO USE
YOUR SANYO MICROWAVE OVEN SAFELY
Although
your oven is provided with safety features,
it is
important to observe the following:
a) It is important not to tamper with safety interlocks.
b) Do not place any object between the oven front face and
the door
or allow
residue
to accumulate
on sealing
surfaces. Wipe the sealing area frequently
with a mild
detergent, rinse and wipe dry. Never use abrasive powders
or pads,
c) When opened, the door must not be subjected to strain, for
example, a child hanging on an opened door or any load
could cause the oven to fall forward to cause injury and also
damage to the door.
Do not operate the oven if it is damaged, until it has been
repaired by a qualified service engineer. It is particularly
important that the oven door closes properly and that there
is no damage to the :
i) Door (bent)
ii) Hinges and Latches (broken or loosened)
iii) Door seals and Sealing surfaces
d) It is dangerous for anyone other than a properly qualified
service ;ngineer
trained by SANYO to "carry out" adjust-
ments or repairs,
NOTE
It is quite normal for steam to be emitted around the door,
or for misting to occur on the door, or even for water
droplets to appear below the door during the cooking
cycle. This is merely condensation from the heat of the
food and does not affect the safety of your oven.
The door is not intended to seal the oven cavity completely
but its special SANYO design contributes to the complete
safety of the appliance.
OTHER SAFEGUARDS:
1. Never remove the cabinet.
High voltage electricity is used in this oven, so be sure no to
remove the cabinet.
2. Be careful not to spill water over the oven, especially, near
the air vents.
3. Do not operate when there is no food in the oven.
Operation of the oven when empty shortens the service life
of the magnetron and causes overheating.
Also, the internal components
of oven melt or burn and
will damage the product.
4. Do not operate without the ceramic tray inside the oven.
The oven can become stained by food burning onto the
base of oven.
~
\n,L
_-
---1.:
--
--..
-.-11-...
-1..
—:-..—
X-:1
—_._,
_t.-.
.._.-
--
6.
7.
8.
9.
10.
11,
vvrval
ixrurwllg,
rwver
trIIuw
crlulillrlulll
IUII,
II IeLdI srwwers
ur
other metallic objects to touch the glass viewing window or
oven cavity.
This may cause sparking
at the point of contact,
may
break the glass, or cause damage
to the oven walls.
Do not do anything that may interfere with the operation of
the upper or lower hinges andlor latches of the oven's
door. Such interference causes unit malfunctions,
Do not use excessive force when pressing the unit's keys,
or press them with metal or sharp utensils or objects. These
can damage the unit and lead to malfunctions.
Do not place or store things on top of the unit, as it can
become quite hot during operation and there is the danger
of melting or harming them.
Keep the plug clean at all times to ensure proper operation.
Do not leave the oven in unattended operation when food
is heated or cooked in disposable containers of plastic,
paper or other combustible materials.
The instruction sheet shall warn the user that the contents
of feeding bottles and baby food jars are to be stirred or
shaken and that the temperature
is to be checked before
consumption
to avoid burns.
12. If smoke is observed,
keep the oven door closed, and
switch off or disconnect the oven from the power supply.
NOTE: If the supply cord is damaged, it must be replaced by
SANYO SERVICE CENTRE, as a special prepared cord
is required, (617 144 6142)
5
Advertisement
Table of Contents
