34 Seats, steering wheel and mirror ›
Stop position change
›
With the ignition off and the driver's door open,
press any button on the seat to be adjusted.
Or:
›
Press the
button on the key.
›
In other cases, release the held memory button.
Settings
Storing driver's seat and exterior mirror position
for driving forwards
The seat position can be stored if the angle of in-
clination of the seat back relative to the seat surface
is less than approximately 110° and the seat is not in
any of the end positions.
Storing front passenger´s exterior mirror position
for reversing
›
Turn on the ignition.
›
Activate the folding function of the mirror in the
Infotainment in the following menu.
Or:
›
Turn the exterior mirror knob to the position .
›
Engage reverse gear.
›
Adjust the mirror to the desired position.
›
Disengage reverse gear.
The set mirror position is saved.
When changing the stored seat and exterior mir-
ror position for forward driving, the passenger exte-
rior mirror position for reverse driving must be re-
stored.
Rear seats
Folding down the seat backs
Before folding down
›
Insert the rear headrests as far as they will go or
remove them.
Rear seats
›
Turn on the ignition.
›
Adjust the seat and the
exterior mirrors.
›
Press the button
A
and within 10 seconds
one of the memory
buttons
.
B
Storing is confirmed by
an acoustic signal.
›
Adjust the position of the front seats in such a way
that they are not damaged by the folded-down
seat backrests.
›
Pull the outer seat belt to the side trim.
Folding forwards from the passenger compart-
ment
Folding forwards from the luggage compartment
Folding back up
Park position of rear seat belts
Applies to Varioflex seats.
›
Press the release han-
dle and fold the seat
forwards.
›
Pull on the lever.
The seat back is un-
locked and partly fol-
ded forwards.
›
Pull the outer seat belt
to the side trim.
›
Fold the seat backrest
back up.
The release handle must
audibly click into place.
›
Check that the seat
backrest has locked in
place. The pin
must
A
not be visible.