Table of Contents
Advertisement
LC-20B2H
LC-20B2M
5-3. TAMP adjustment
1) Feed the color bar pattern signal.
2) See if the "Y" reading on adjustment process page 2 is within the range shown below. If not, adjust the "NTSC
TAMP" setting to bring the "Y" reading within the specified range.
3) If the "NTSC TAMP" setting has been readjusted, write down its new setting in the "PAL TAMP", "SECAM
TAMP", "PAL-M TAMP" and "PAL-N TAMP" items manually.
(Page 2 of adjustment process OSD)
5-4. White balance adjustment
1) Feed the monoscope pattern signal.
2) Adjust the "RCUTOFF" and "BCUTOFF" settings on adjustment process page 2 to achieve the color at the same
level as with the standard set.
Note: Keep the "RCUTOFF" and "BCUTOFF" settings as an odd number, whenever possible, in the range below.
• • • -9, -7, • • • -1, +1, • • • +7, +9 • • •
If set to an even number, horizontal streaks may occur with a specific-gradation monochrome signal.
Model
LC20B2
Adjustment value
BB ~ CA
10
Y data
75% White
Advertisement
Table of Contents
