General Parameters; Bluetooth Commands; Bluetooth Reset (Bluetooth Has To Be On); Switching To Hid Mode (By Sending Via Usb Cdc Bluetooth Must Be On) - TECTUS Multipen Series Command Manual

General parameters:
The SPP Bluetooth and USB (CDC) communication between the host and the Multipen is line oriented. A line is
a sequence of ASCII characters ended by a CR character (ASCII code 13).
The communication settings of the Multipen are 9600 bps, 8 bits, no parity bit and 1 stop bit. No handshake.
For testing the communication you can use our PC Programm TIDMultipen V.1.5.
1.0 Bluetooth Commands
1.1 Bluetooth Reset (Bluetooth has to be ON)
Command: br
Example: br
Answer MP: [BTM]:Reset done
1.2 Switching to HID mode (by sending via USB CDC Bluetooth must be ON)
Command: bh
Example: bh
Answer MP: [BTM] now in HID mode
1.3 Switching to SPP Mode (by sending via USB CDC Bluetooth must be ON)
Command: bs
Example: bs
Answer MP: [BTM] now in SPP mode
2.0 System Commands
2.1 Show battery status
Command: sb
Answer MP: [Bat]:88% charging....
2.2 Set Date Multipen
Command: sb TT.MM.JJ
Example: sd 27.06.17
Answer MP: [RTC]: Date set to 27.06.17
2.3 Set Time Multipen
Command: st HH.MM
Example: sd 14:00
All Bluetooth settings reset to factory default !
Seite 4 von 11