Stopping Your Engine And Short-Term Storage; Maintenance - Tecumseh Power OV195EA Operator's Manual

VI. Stopping Your Engine and
Short-Term Storage
Stop engine according to equipment manufacturer's
instructions.
To avoid unsupervised operation of
WARNING
an engine, especially by children,
NEVER leave it unattended when it is running. Always turn
off the engine after use and remove ignition key, if
provided. Failure to do so may lead to serious injury or
death.
NEVER store engine with fuel in the
WARNING
fuel tank inside a building with
potential sources of ignition such as hot water or space
heaters, clothes dryers, electric motors, etc. Doing so may
lead to an explosion resulting in death or serious injury.
VII. Maintenance
To avoid serious injury or death, an
WARNING
adult should perform maintenance on
this engine. Only allow children to perform maintenance if
an adult has determined they are experienced and capable
of such operation.
To prevent accidental starting when
WARNING
working on equipment, always:
• Carefully disconnect spark plug wire and keep it
away from spark plug. See Figures 26 and 27.
• Keep the disconnected spark plug wire
securely away from metal parts where arcing
could occur.
• Carefully attach the spark plug wire to the
grounding post, if provided.
• Disconnect battery at negative terminal first, if
engine is equipped with a DC electric starter.
• Turn all engine switches to "OFF" position.
• Remove ignition key, if provided.
181-1272-14 Four-Cycle Engine • Vertical Crankshaft • Air-Cooled
Figure 26. Disconnecting/Connecting Spark Plug
Figure 27. Typical Spark Plug Connection
A. Checking and Changing Oil
To avoid engine damage, it is important to:
• Check oil level before each use and every 5
operating hours when engine is warm. See
"A. Checking Oil Level" instructions on page 5.
Afterward, continue reading instructions below.
• Change oil after first 2 operating hours and every 25
operating hours thereafter; more often if operated in
extremely dusty or dirty conditions. Engine should
still be warm but NOT hot from recent use.
1. Carefully disconnect spark plug wire and keep it away
from spark plug. See "G. Avoid Accidental Starts"
instructions on page 2. See Figures 26 and 27.
Afterward, continue reading instructions below.
• Keep the disconnected spark plug wire
securely away from metal parts where arcing
could occur.
• Carefully attach the spark plug wire to the
grounding post, if provided.
Page 13