Advertisement
VOLUME CONTROL
Volume Down
Volume Up
CHECK BATTERY LEVEL
Press both volume buttons simultaneously. (Short Press)
CHANGE EQ SETTINGS
The House Party is pre-loaded with 2 EQ settings (outside or inside). To change settings, hold both volume buttons for 3 seconds. (Long Press)
SHARE MODE (LINK SPEAKERS)
1
Power ON chosen Main/Sharing speaker.
JLab
Block Party
2
Power ON the other House Party or Block Party speaker(s) to enter them in Receive Mode as follows:
If you see the white rotating ring then you are already in Receive Mode.
Follow Step 3.
If you see the blue pulsing light
3
Press and hold 3 seconds the Share Mode / Receive Mode button
Green lights on ring will indicate volume level on speaker.
Note: Volume on the speaker works independently from your Bluetooth
device. Adjust the volume on both the speaker and your device accordingly.
Purple lights on ring will indicate battery level on speaker.
The logo will flash green for outside and flash blue for inside.
Connect the speaker to your Bluetooth device.
Once connected, set this speaker aside until step 4.
(Follow the Connect Your Bluetooth Device instructions
if speaker is not connected to your device)
White blinking ring will indicate that it is set to receive. All receiving speakers must be blinking white to link
to Main/Sharing Speaker.
Quick press the Bluetooth / Receive Toggle Button
White rotating ring will indicate Receive Mode.
Follow Step 3.
Advertisement
