Strange Noises - Jensen Flexi Assembly And Instructions For Use

UK
1
D
2
F
NL
ESP
Using the remote control
N
The remote control is used to adjust the bed's
movements.
S
Summary of remote control functions:
1. Raise head end
2. Lower head end
FIN
3. Raise foot end
4. Lower foot end
5. Raise head and foot end simultaneously
6. Lower head and foot end simultaneously
DK
Assembly / Getting started
First of all you should check whether all the parts
PL
have been supplied by referring to the summary on
the folder's left-hand page.
1. Fit the legs into the corner attachments on the
frame and place the bed on its feet (see illustra
tions 1a and 1b).
2. Assemble the side brackets using two screws
at approx. 75 cm from the head end, measured
on the inside of the frame (see illustration 2).
If two frames are to be fitted together to create a
double bed there is no need to fit any brackets
between the two beds.
3. Place the Flexi in the frame. N.B.!! Do not
remove the red tape holding the frame together
but do remove the tape around the motor (see
illustration 3).
4. Hook the end stop to the frame and tip it up until it
is perpendicular (see illustrations 4a and 4b).
Fasten with screws.
5. Remove the red tape that is holding the frame
together.
6. Place the mattress and the topper on the
frame.
7. Then insert the plug into the socket. Read the
instructions for using the remote control and
simply start using the bed.
4
3
5
6
4
Introduction
Congratulations on the purchase of your Jensen Flexi adjustable bed.
We hope that it gives you many years of comfortable days and nights.
We recommend that you study this manual closely before you start
assembly/installation.
Guarantee
If used normally, your Jensen Flexi is guaranteed for 5 years. The
invoice on which the date of purchase is stated serves as a certificate
of guarantee. In the event of any faults or malfunctions, please contact
the store from which you purchased the bed.
Degree of hardness
The degree of hardness of the middle section of the bed can
be adjusted. Moving the plastic rings around the double strips
towards the middle makes the base of the bed softer and moving
them to the edge does the reverse.
Solving malfunctions yourself
If the motor does not work, check whether the plug has been
inserted correctly into the socket and whether power is actually
being supplied to the socket. In order to reset the electronic func-
tions, press the green button on the plug. You should also check
whether the cabled plug of the remote control is fitted properly to
the motor.
Do not open the motors or the remote control yourself. The manu-
facturer accepts no liability if this has been done by anyone who
is not an authorised service technician. New cables, motors and
remote controls should be ordered from the manufacturer.

Strange noises

A mechanical and electrically adjustable bed generates noise. In
most instances, the amount of noise that the bed makes depends
on the acoustics of the room in which the bed is situated.
Usage
The bed's lifting motors are not designed for continuous usage.
The bed will only continue to be reliable and operate normally if
the motors do not work for longer than 2 minutes during a 15 minu-
te period. Any attempt to exceed this degree of usage will reduce
the life of the product and may render the guarantee invalid.
The bed has been constructed in such a way that it can bear a
maximum weight of 150 kg, distributed equally between the head
end and the foot end. Any attempt to exceed this degree of usage
will damage the product and may render the guarantee invalid.
Important: do not sit on the head or foot end of the bed if raised.
Electrical data
Input: 230V AC 50/60 Hz.
Operates on 24 V DC.
Consumption: 50W