Front Panel Controls And Connection Options; Preparation For Remote Control - Technika LCD32-407B Operating Instructions Manual

FRONT PANEL CONTROLS AND CONNECTION OPTIONS

Front control panel
S-VIDEO2
VIDEO
R
AUDIO
L
ANT IN
Remote sensor
Power indicator
7
COMPONENT IN
Y Pb/Cb Pr/Cr
1 2
1. HDMI input
2. PC input
3. COMPONENT input
4. Earphone output
5. SCART input
6. S-VIDEO input
7. PC audio input interface
Note: 1. Do not connect both AV and SCART2 at the same time.
2. Do not connect both S-VIDEO2 and VIDEO at the same time.
3. Do not connect both COMPONENT and S-VIDEO1 at the same time.
4. When SCART1 and SCART2 is input at the same time, SCART2 is prior.
Source button
Menu button
MENU
VOL+
Volume down/up button
VOL-
CH+
Program down/up button
CH-
Standby button
6
SAV IN
S-VIDEO 1
SCART1(RGB)
AUDIO
L R
SCART2(AV)
5
4
3
5

PREPARATION FOR REMOTE CONTROL

Remote control installation
1. According to the figure display below, place the remote control with face down,
then open the cover of the battery apartment.
2. As in the figure display below, install two AAA batteries. (The + and - symbol of
battery must match with the marks on the remote).
3.Close the cover of the battery apartment.
1
2
Cautions for using remote control:
Confirm there is no object between the
remote control and the remote sensor
of TV set.
Do not put the remote control in direct
heat or a damp place, or potential
damage to the remote may occur.
3
Sunshine or other strong light will
interfere with the signal sent by the
remote control. In this situation turn
the TV set to avoid the direct light
source.
Please use two AAA 1.5V batteries.
Do not mix battery types.
Install the batteries as the correct
polarities.
Do not use rechargeable batteries.
If your TV is to be stored for a period
of time, remove the batteries from
the remote control.
6