ECUE Butler PRO Setup Manual page 17

up in the list, check if the IP address settings for your computer are correct and the
network range is 192.168.123.*, the default address of any new Butler PRO is
192.168.123.1. Please also make sure your fire wall does not prevent communica-
tion between the computer and the Butler PRO. The Butler PRO should become
visible.
Click on the Butler PRO line in the
Network display, this opens the
device configuration dialog. Here
you can set all driver properties of
the Butler PRO. The IP address
typically this
should read 192.168.123.1 at this
stage, when the Butler PRO is still
set to factory defaults.
y Assign a new IP address e.g.
192.168.123.200.
y Use the same procedure for
the remaining network param-
eters: Subnet Mask - usually
255.255.255.0, Gateway – no
gateway
y Give the Butler PRO a unique
name.
y Apply the changes with the Ok button
The parameters to configure in online mode are the same as configuring the Butler
PRO manually. Additionally a new password may be set and the DMX parameters
can be changed. Parameters in grey are read-only and cannot be changed, like the
MAC address or the version numbers. If the password is omitted, the setup will not
be protected.
Setup Manual - Butler PRO
17