ECUE Butler PRO Setup Manual page 13

y For the device name press the OK key to initialize editing mode and select position
and value as above. Press OK again to get to the command selection in the top
row. With the
cross to cancel, the checkmark to apply the changes or the back-arrow to delete
the characters in the name. Press the OK key.
With the parameter Advanced settings > an additional level of functions is
entered for special features. Use the
level to return to operational mode. In the setup parameters there is an additional
command set for Test Mode. Select this test mode by pressing the right-key when
Enter Test Mode > is displayed.
Setup parameters and values
Standard parameters
enter Password
Setup IP
192.168.123.200
Setup Subnet Mask
255.255.255.000
Setup Gateway
192.168.123.001
Setup NAME
Butler PRO
Setup GROUPID
001
Setup STARTUP
show snapshot1
Setup OFFLINE
show snapshot2
Advanced settings >
or key select to save, cancel or delete characters. Select the
With the cursor keys
with
password.
The IP address of the Butler PRO. Factory default
is 192.168.123.1
The subnet mask. Default is
255.255.255.0
The network gateway. If no gateway is use,
set to 0.0.0.0
The device name, used in most displays.
Set the group id for synchronisation of snapshots
in a set of Butler PRO.
Setup the show to display on startup, snapshot 1,
snapshot 2 or no output.
Setup the show to display if the Butler PRO is of-
fline, select snapshot 1, snapshot 2 or no output.
Enter the Advanced Settings mode.
key to leave this menu or any other menu
and
or characters. Press OK to enter the
Setup Manual - Butler PRO
select position and
13