ECUE Butler PRO Setup Manual page 15

are faded from zero to a defines value in a loop. In strobe mode all channels get a
square signal to realize a strobe effect.
After selecting from the advanced settings you reach level one of the test mode:
select Output
none
select Output
>none
Set Level
255
select Test Mode
value
Output Mode
dmx
For the test of a subset of fixtures you can select a block size and block move value
with the key. This submenu is reached in every position of the first level as a
second level. Use
Block size
<value>
Universe size
512 (def DMX)
Select the outputs to test. Press the OK key and
select the tested outputs with the next step.
With the
output of the Butler PRO. Press the OK key again
to set the output channel(s) and return.
Press the
test mode.
Press OK, use the cursor keys to select and set
position and value of test brightness. The
maximum value is 255. Press OK to set this value.
Press
Press Ok, with the
mode: value, fade or strobe. Press OK again to
select the test mode. The test mode runs until
you leave test mode with the
Select the output mode dmx or epix
Butler PRO e:pix only.
or to navigate.
To select a block size, press OK and select 1, 2,
3, 4, 5, 6, 48, 192 or 512 channels. Press OK
again to set the block size (Butler PRO DMX)
Select the size of one universe for the Butler PRO
e:pix only.
key select all, none or a single
or
to select the maximum brightness in
to select the test mode.
or
Setup Manual - Butler PRO
key select the test
key.
15