AEG S93880KMB3 User Manual page 38

38 www.aeg.com
This work is to be carried out by a skilled
plumber.
There are different type-approved taps
and tap assemblies on the market.
The water hose must not be cracked,
squeezed or put in tight bends.
The safety valve provided in a package
inside the appliance should be used to
prevent overflow. Before the safety valve
is placed on the tap, turn the pointer
clockwise to number 10 with the
enclosed plastic key. Install the safety
valve on the tap and let at least 10 litres
of water flow through the device. Before
connecting the appliance turn the
pointer to number 1 on the safety valve.
If the safety valve has shut off, detach it
and press the red plunger which is
located inside the lower housing of the
device itself.
Before the appliance is placed its final
location, ensure that the water
connection has been correctly carried
out, that there is no leakage at the
connection to the water tap.
Tighten the screw enough by hand.
Make sure that the gasket is properly
positioned in the connector.
We recommend that the appliance is
placed on a "run-off" mat intended for
refrigerators and freezers, which makes it
easier to detect possible leakage
8.8 Installation of the Clean Air
Control filter
CAUTION!
The filter should be handled
carefully so fragments do
not loosen from the surface.
Make sure that the air lever
flap is closed to obtain
proper function.
The Clean Air Control filter is an active
carbon filter which absorbs bad odors
maintain the best flavour and aroma for
all foodstuffs without risk of odor cross
contamination.
On delivery the carbon filter is in a plastic
bag to preserve performance.
1. Open the air lever flap.
2. Take the filter out of the plastic bag.
3. Insert the filter in the slot found in
the back of the air lever flap.
4. Close the air lever flap.
8.9 Starting the water system
for the first time.
Ensure proper connection to the water
supply, refer to "Connecting the water
hose".
1. Open the tap on the water
connection.
2. Start the refrigerator.
The water system main valve opens and
the pump starts to fill the system.
Water from final inspection
testing may be resident in
the appliance. Dispense and
discard at least 2 litres of
plain water and 1 litre of
carbonated water prior to
use.