for Inkless Print Cylinder (Drum)
The following procedures are required when installing the Print cylinder (Drum), after the
preparation of installing the printer.
Important !
Be sure to follow the given instructions, or the warranty on this Print cylinder (drum) may be invalidated.
Nobody but Riso-authorized service representatives is allowed to install this unit.
1. Print Cylinder (Drum) Preparation
1) Insert an ink cartridge into the Print cylinder (drum).
Lead ink to the nozzle of the cartridge in advance.
Important !
Be sure that the Print cylinder (drum) temperature is above 59 °F (10 °C).
2) Close the Front cover.
3) Plug the power cord of the printer and start up the test mode.
4) Press the Reset key when the error code "No. D04-534" appears.
5) Input the test item code "No. 117" and press the Start key.
6) Press the Stop key.
7) Input the test item code "No. 890" and press the Start key.
8) Turn the power switch off.
9) Start up the test mode.
10) Input the test item code "No. 887" and press the Start key.
When the ink supply action is completed, a buzzer sounds.
NOTE : If the action is interrupted, restart the test mode "No.887".
11) Restart the printer to quit the test mode.
2. Operation Check
1) Make a master with Riso test chart, and print 200 copies at speed 3.
2) Check density balance and if necessary, re-adjust the gap between
Squeegee roller and Print cylinder (drum) body.
3. Labeling
Affix the following labels on the Print cylinder (drum) as illustrated.
- Ink color indication label
- Caution label (for UI print cylinder (drum) only )
This document is printed on recycled paper.
Installation Procedure