Braun ExactFit 3 Manual page 8

Morning average (for BP5900PH-EMEA only)
• Press the "average
average " mode, the morning measurements
in memory within past 7 days will show on LCD.
• If there is no data in memory within past 7
days, " " will show on LCD.
Evening average (for BP5900PH-EMEA only)
• Press the "average
average " mode, the evening measurements in memory
within past 7 days will show on LCD.
• If there is no data in memory within past 7 days, "
show on LCD.
Erasing data
• Press the "memory
• Press and hold the "mode
"set " (4) button, all the stored data will be erased and
CLR will show on screen.
• To check if the data was erased, press the "memory
button. No data should show up on screen, but date, time
and M:00.
Morning hypertension setting (for BP5900PH-EMEA only)
Morning hypertension symbol
pre-configured systolic rate and/or pre-configured diastolic rate, and/or one or both of
these measurements is 20% or more above evening average.
** Your pre-configured systolic / diastolic should be decided between you and your
doctor or healthcare provider.
• After setting date and time, press "mode
"morning hypertension
position will flash for systolic setting.
• Press "set " (4) button, LCD will appear 135 mmHg for SYS
as the internal pre-set value, then press "Set
repeatedly to set his own value (range from 70~250 mmHg)
• Press "mode " (5) button again into "morning hypertension
" setting mode " - - " on diastolic position will flash for
diastolic setting.
• Press "SET " (4) button, LCD will appear 85 mmHg for DIA
as the internal pre-set value, then user presses "set
to set his own value (range for DIA is 40 ~ 115 mmHg).
• User can press start/stop
and go back to standby at any step.
8
" (3) button again into "morning
" (3) button once again into "evening
M
" (2) button into memory mode.
" (5) button and then press the
will appear when morning average is above your
" setting mode "- - " on systolic
(1) button to exit setting mode
" will
M
" (2)
" (5) button into
" button
" button