Master DH 711 Operating Manual page 6

EMPTING THE WATER TANK
When the water tank is full, the unit will switch off automatically and the 'Water
Full' indicator will turn into red. At this time, please empty the water as follow:
• Grasp the attached handle, pull the water tank slightly up and then pull lightly
out for easy removal.
• After the water is emptied, push the water tank back into space.
Note! If the tank doesn't position well, the 'Water Full' indicator will remain in red
light.
Optional: For long time operation, please refer to the following:
1. Remove the water cap from
the rear cabinet. Connect the Hole A
drain hole A with a water tube of
diameter 6 mm. (fig. 4, 5)
fig. 5
2. Pull out the water tank, put
the water cap of the rear cabinet
on the drain hole B found in the
compartment. (fig. 6)
fig. 4
3. Ensure the water will always
Hole B
drain away freely and the hose
will remain in place.
4. Put back the water tank. (fig. 7)
5. Note: In very cold weather
conditions, precautions should be
fig. 7
taken to prevent the drainage pipe
fig. 6
from freezing.
7