Getting Started - THOMSON 27LB120S4 - annexe 1 Owner's Manual

3. GETTING STARTED

Switching on
Follow the instructions on this page on how to switch on your TV set and the remote control before going on to following
pages describing how to use the remote control and the channel set-up procedure.
220-240 V~50 Hz
Mains socket in uk
1.
2.
Equipment for the UK is supplied with a mains cable fitted with a
moulded plug.
This pl u g contains safety components and must not be replaced
by one sold by general retailers. It is fitted with a fuse that
protects your television.
If your set has stopped working, the fuse may have blown. If it
Mains socket in
Continental Europe
has, replace it with an identical ASTA or BSI certified (BS1362)
5-amp fuse.
3. Connect the outside aeri
socket at the back of the TV set.
The aerial socket (75 Ohms - VHF / UHF / cable) can be used
for connecting an external aerial or other equipment fitted with a
modulator (video recorder, satellite receiver, etc.).
We recommend that you do not connect other equipment (video
recorder, satellite receiver, etc.) to your TV set to begin with, so
as not to complicate the set-up procedure with the additional
steps involved. Connect them when you have fi n ished setting up
the channels by referring to page 21 of this manual.
4. Switch the TV on by pressing the on/off button on the
right side.
You will find a description of how to use the remote control on
page 9. Then go to page 11 for information on the initial set-up,
or to page13 for information on manual set-up (if the channel s
have already been set up on your TV).
Connect the female plug to AC power input of the set.
Connect the male plug to the wall outlet as
illustrated.
8
or cable network to the
al