Memory Channel Recall; Memory Shift; Memory Channel Clear - ADI AR-147 User Manual

CALL Channel
1. Select the desired operating frequency in VFO mode or the
desired memory channel in memory channel mode, and be sure
that PAG/C.SQ not activated.
2. Select the desired offset frequency, tone frequency, etc.
(For example 145.500 MHz in VFO mode)
3. Press the F key. The F indicator and the memory channel
indicator will light.(For example CH8)
4. Press the CALL key within 10 seconds of pressing the F key. The
F indicator and the Memory Channel number will turn OFF, to
confirm data entry.
Note CALL channel entry operates only when PAG/C.SQ feature
disabled.

5-4-6 Memory Channel Recall

1. Press the MR/M key.
2. Rotate the tuning control or press the microphone UP/DN switches
to select the desired memory channel.

5-4-7 Memory Shift

This feature copies Memory channel or CALL channel data to the VFO.
This will allow you to recall and alter these frequencies without changing
the actual contents of the memory or CALL channel.
1. Press the MR/M key or CALL key.
2. Press the F key. The F indicator will light.
3. Press the VFO /M V key within 10 seconds of pressing the F key.
The F indicator and the Memory or CALL channel indicator will turn
off to signal the data has been successfully transferred to the VFO.

5-4-8 Memory Channel Clear

1. Enter the memory channel recall mode and select the desired
memory channel.
2. Press the Power Switch to turn off the transceiver.
3. Press and hold the MHz key and turn on the transceiver. Release the
MHz key, the confirmation message will appear on the display.
4. Press MR/M key in 5 seconds, the contents of the selected memory
channel are erased.
19