Operation; Troubleshooting Information - Wolf Garten POWER Base 72V Basic Original Operating Instructions

EN

Operation

Injuries or material damage.
¾ Note the mains voltage.
¾ The voltage of the current
source must match
the information on the
identification plate of the
device.
Note
The power pack becomes hot
during operation.
Charging (Fig . A)
Plug the charger into a suitable socket
Î
A1.
3 The LED goes red.
Plug the power pack into the charger
Î
A2.
3 Charging starts and the LED goes
green.
Note
After approximately 90 minutes
the power pack is 80% charged
and after about 110 minutes it is
fully charged.
Risk of injuries or material damage.
¾ Pull out the mains plug.
¾ Do not open the device.
¾ In case of doubt always consult a specialist workshop.
12 | | POWER Base 72V Basic
CAUTION !

Troubleshooting information

LED charge state indicator
LED status
Steady red
Flashes green
Steady green
Quick flashing red
Slow flashing red
Steady red
Note
To protect the power pack and
ensure a long service life, the
charger switches off as soon as
the power pack is fully charged.
¾ Store the power pack and charger
separately.
WARNING !
Operation
Meaning
Mains voltage con-
nected.
Charging.
Charging completed.
Power pack possibly
defective. Arrange for
testing of the power
pack by a specialist
workshop.
Power pack too hot or
too cold. Charging starts
automatically if the
operating temperature is
correct.
Power pack is not
charging. Power pack is
not correctly inserted or
the contacts are dirty.
Note