Troubleshooting - La Crosse Technology WT 481 Instruction Manual

TO USE THE HI-LO-OFF DIMMER
This clock radio features an adjustable display backlight with "high / low / off" settings. To select a
backlight setting, press SNOOZE/DIMMER one at a time until the brightness is reached. This can
only be done when the radio is off.
Note: Please note the always-on backlight will not work while the clock is operating on battery power.
TO SET UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for best FM reception. Do not strip, alter or
attach to other antennas.
TO TUNE AND PLAY THE RADIO
Press SLEEP/RADIO, the LCD will show "ON" for few seconds and then shows the radio frequency
readings in Mhz.
1. Press
few seconds and release. The radio will search and stop on the next strong station.
2. Press
to 15 (maximum)
3. Press SNOOZE/DIMMER to turn off the radio.
Remark: keep your radio away from fluorescent lamps, which may cause interference to the radio.
TO USE THE MEMORY SET (RADIO PRESET) FUNCTION
This clock radio features a total of 10 preset memory of FM radio .These allow you to preset your
favorite stations and access them quickly.
1. Turn on the radio by press of RADIO / SLEEP. Press
like to preset memory.
2. Press and hold the SET / MEM until "MEM" appears and "01" flashes below the time digits.
Press and hold SET / MEM until "01" stops flashing. The preset is now stored in Memory
01.
3. Press
until "MEM" appears and "01" flashes below the time digits. Press SET / MEM once, "02"
appears. Then press and hold SET / MEM to store Memory 02.
To move to next preset without storing, repeatedly press the SET/MEM button.
4. Repeat Step 2 - 3 to preset up to ten FM stations.
5. To listen to a preset station at any time, simply press the SET / MEM to select a preset
station while the radio is on.
6. To edit a preset station, select another station and then repeat Step 2-4. This overrides the
original setting.
TO USE THE SLEEP TIMER
1. Press the RADIO/SLEEP twice to enter the sleep mode. The clock display shows the
SLEEP icon and "5" (5 minutes) and flashes keep pressing the RADIO/SLEEP to select a
10-, 15-, 30-, 45-, 60-, 75-, 90-minute sleep timer. The sleep timer display remains for few
seconds and then returns to normal clock display. The SLEEP icon will appear, showing
the radio timer is activated.
2. The radio will play for the programmed sleep time and then shut off. To check how many
sleep time is remaining, press RADIO/SLEEP once.
3. To turn off the radio before the sleep time has elapsed, press SNOOZE/DIMMER once.
TROUBLE SHOOTING
If your clock displays irrelevant time or does not function properly, which may be caused by electro-
static discharge or other interference, use a thin object to press the RESET button at the back. The
clock radio will be reset to default settings and you need to set it again.
/ to tune into a desired radio station. To scan the stations, press
once, the LCD shows "VOL", press
/ to select another station you like to preset. Then press and hold SET / MEM
/ to adjust volume from 01 (minimum)
/
EN. 3
/
to select a radio station you
for a