Advertisement
5.
Using a Philips screwdriver, remove the
small tilt range screw from the coupling
bracket on the fan neck and then unscrew
the tilt range knob.
NOTE: It is important that the post and fan
head are in the correct orientation when
assembled.
6.
The top section of the post has a small
horizontal open slot on one side and a
small horizontal depression on the other
side as shown.
Depression
The side with the open slot is for the small tilt
range screw. The side with the small
depression is for the tilt range knob to tighten
up onto.
7.
Take the head assembly and position the
mating section over the post end as
shown.
Depression
this side
Assembly (cont.)
8.
9.
10. Using a Philips head screwdriver, screw in
Open slot
11. Screw on the tilt adjustment knob and
Slide the tilt adjustment bolt all the way
through as shown.
Screw in the tilt range knob to loosely
secure.
the small tilt range screw and tighten.
tighten.
Advertisement
