Hilti NPR 019 IE-A22 Manual page 9

▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless electro-hydraulic crimping tool.
It is designed for crimping fittings used to connect composite, copper (Cu) and steel pipes.
Use only Hilti lithium­ion batteries of the B 22 series with this product.
•
• Use only Hilti-approved battery chargers to charge these batteries. More information is available from
your Hilti Store or from www.hilti.group
3.3 Possible misuse
• Do not use this hand-held product clamped in a fixed position or as a stationary device.
• This electro-hydraulic crimping tool may not be exposed to heavy rain or used under water.
3.4 Lithium­ion battery status display
The charge state of the Li-ion battery and malfunctions of the product are indicated by the indicator of the
Li­ion battery. The state of charge of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED flashes.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the LEDs of the charge state indicator flash, follow the instructions
in the 'Troubleshooting' section.
3.5 Items supplied
Crimping / pressing tool, operating instructions.
*2207112*
1
2207112
Crimping / pressing head
@
Piston return switch to open the crimping /
;
pressing jaws in the event of a fault or emer-
gency
Casing
=
Servicing and fault indicator (red LED)
%
Battery release button
&
Battery
(
Slot on both sides to fasten the Hilti retaining
)
leash
White LED to illuminate the working area
+
Control switch
§
Locking pin for opening/closing the tool head
/
Crimping / pressing jaws
:
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
English 5