Page 2
KURTYNY POWIETRZNE Instrukcja obsługi i montażu PLATINUM PTN - 90CX PLATINUM PTN -120CX PLATINUM PTN -150CX Dziękujemy za zakup kurtyny powietrznej KAISAI. Prosimy o zapoznanie się z instrukcją przed użyciem urządzenia.
Page 3
KURTYNY POWIETRZNE 1. TYPOSZEREG – WYMIARY INSTALACYJNE [mm] MODEL masa netto (kg) 12.5 PTN-90CX 1200 15.5 PTN-120CX 1500 PTN-150CX Strona tylna 2. ZALECENIA INSTALACYJNE Należy przestrzegać następujących zaleceń instalacyjnych: 2.1 Kurtynę należy montować do stabilnego podłoża, aby zapewnić pewne i bezpieczne zamoco- wanie.
Page 4
2.2 Montaż urządzenia jest dozwolony tylko we wnętrzu pomieszczenia. strefa strefa zewnętrzna wewnętrzna 2.3 Nie instalować urządzenia zbyt nisko, minimalna wysokość montażowa wynosi 2,3 metra. 2.4 W przypadku gdy otwór drzwiowy jest szerszy niż kurtyna, zalecany jest montaż dwóch lub więcej urządzeń.
Page 5
KURTYNY POWIETRZNE 2.6 Instalować urządzenia w miejscach, w których nie będą narażone na rozbryzgi wody, wpły- wy pary wodnej oraz wybuchowych lub żrących gazów. 3. INSTALACJA 3.1. Montaż do ściany betonowej: 3.1.1 Zdjęcie płyty montażowej. Zdjąć części plastikowe, zwalniając śruby na tylnej stronie głównego korpusu w celu zdjęcia płyty montażowej.
Page 6
3.1.3 Następnie przykręcić płytę montażową, stosując kotwy do betonu, podkładki i nakrętki zgodnie z poniższym rysunkiem. podkładka podkładka sprężysta nakrętka płyta montażowa 3.1.4 Montaż urządzenia. Oprzeć urządzenie o górną krawędź płyty montażowej i zatrzasnąć w pokazany niżej sposób. Przykręcić śruby mocujące płytę montażową do kurtyny.
Page 7
KURTYNY POWIETRZNE 3.2.2 Wykonać czynność z punktu 3.1.4. 3.3 Montaż do sufitu 3.3.1 Należy odłączyć płytę montażową od urządzenia (zob. 3.1.1). płyta montażowa śruba montująca 3.3.2 Montaż uchwytów sufitowych. podkładka podkładka sprężysta nakrętka...
Page 8
3.3.3 Następnie założyć płytę montażową na przygotowane mocowania. Dokręcić płytę monta- żową do uchwytów sufitowych. podkładka podkładka sprężysta nakrętka płyta montażowa 3.3.4 Wykonać czynności opisane w punkcie 3.1.4 i zamocować urządzenie. 3.4 Montaż nad sufitem 3.4.1 Należy postępować tak jak w przypadku montażu do ściany betonowej.
4. PARAMETRY TECHNICZNE Napięcie Max. prędkość Przepływ Poziom Moc silnika (W) Częstotliwość powietrza (m/s) powietrza [m hałasu [dB] MODEL (V~) (Hz) PLATINUM PTN-90CX 1600 1300 PLATINUM PTN-120CX 2400 1950 PLATINUMPTN-150CX 3150 2550 5. SCHEMAT ELEKTRYCZNY...
6. OBSŁUGA URZĄDZENIA 6.1 Włączyć przycisk zasilania. 6.2 Wybrać właściwą prędkość wentylatora: High [H]- wysoka, Low [L]- niska. 6.3 W zależności od miejsca montażu ustawić kierownice powietrza tak, aby uzyskać najlepszy efekt. 7. WAŻNE OSTRZEŻENIA a) Zasilać urządzenie tylko prądem o parametrach określonych na tabliczce znamionowej.
Page 11
AIR CURTAINS CURTAINS INSTALLATION MANUAL PLATINUM PTN - 90CX PLATINUM PTN -120CX PLATINUM PTN -150CX Thanks for purchasing KAISAI Air Curtain. Please read these instructions carefully before use.
1. IDENTIFICATION & INSTALLATION DIMENSIONS [mm] MODEL Net weight (kg) 12.5 PTN-90CX 1200 15.5 PTN-120CX 1500 PTN-150CX back side 2. INSTALLATION CAUTIONS Must follow the following asking when installing air curtain: 2.1 Please install the unit in a sturdy place to avoid the shaking and ensure its security (because it maybe cause the wall becoming flexible or shaking and noise).
Page 13
AIR CURTAINS 2.2 Please install the unit inside the room. outdoor indoor 2.3 Don’t install the unit too low, no less than 2.3 meter from the ground. 2.4 When the entrance is wider than the unit, it is recommended to install two or more units in parallel.
2.6 Don’t install the unit in a place where it is splashed by water, exposed to excessive steam, explosive gas or corrosive gas. 3. INSTALLATION 3.1. Installing on the concrete wall: 3.1.1 Removed the mounting plate. Unclamping the fixed screws on the back of main body to removed the mounting plate.
Page 15
AIR CURTAINS 3.1.3 When the cement has freeze, fit the mounting plate (use the washer and nut according to the following). washer spring washer mounting plate 3.1.4 Installation of the main body. Set the main body onto the upper end of the mounting plate and clamp it as shown. 3.2 Installing on the wooden wall: 3.2.1 Fix the mounting plate in the proper positions with tapping screw.
Page 16
3.2.2 Same as the step 3.1.4. 3.3 Hanging from the ceiling: 3.3.1 Remove the mounting plate from main body (same as step 3.1.1). mounting plate fixing screw 3.3.2 Fixing ceiling brackets as Fig. washer spring washer...
Page 17
AIR CURTAINS 3.3.3 Set the mounting plate on the ceiling brackets and ensure safe & fixing (use the bolts atta- ched to the ceiling brackets as Fig). Using the ceiling brackets to hang from the ceiling, the position of mounting plate can be adjusted in the limit of 100mm. washer spring washer mounting plate...
3.4.2 Then pipe as right Fig. Instructs. wind piping ceiling 4. HEATED MODEL TECHNICAL PARAMETERS Motor Power Max. air speed Air volume Noise Volt. Freq (m/s) [dB] MODEL (V~) (Hz) PLATINUM PTN-90CX 1600 1300 PLATINUM PTN-120CX 2400 1950 PLATINUMPTN-150CX 3150 2550 5. WIRING DIAGRAM...
AIR CURTAINS 6. OPERATION 6.1 Turn on the power switch. 6.2 Select the best speed: High[H], Low[L]. 6.3 According to using to adjust the grate to obtain the best effect. 7. CAUTIONS a) Use the unit at the rate voltage and frequency indication on the nameplate. b) Disconnect power source before unit operation.
Need help?
Do you have a question about the PLATINUM PTN-90CX and is the answer not in the manual?
Questions and answers