Finishing A Seam - Smartek RX-01 Operating Instructions Manual

FINISHING A SEAM

♦ When finish sewing raise the needle arm
to the highest position by turning the
rotary wheel. Use the back of a seam
ripper or scissors to pull the thread out
about three inches then cut it see
diagram
♦ Turn the rotary wheel, lowering the
needle into the cloth. Continue to turn the
rotary wheel until needle arm is again at
its highest position.
♦ Lift up the fastening plate and take off
the cloth to the left, making sure not pull
the thread out the seam doing so can
cause the seam to unravel.