How To Thread; Thread Tension - Smartek RX-01 Operating Instructions Manual

HOW TO THREAD

♦ Note* The spring must be in place before
installing bobbin Thread should flow from
the top right of the bobbin or spool.
♦ Pass thread through the eyelet on the
needle arm
♦ Pass thread over top of tension control.
Do not wrap completely around tension
control
♦ Use the threader to pass the thread
through the needle eye from back to the
front.

THREAD TENSION

♦ If stitching is too tight, turn tension
control slightly to the left.
♦ If stitching is too loose, turn tension
control slightly to the right.