Advertisement
To ensure correct operation, connect the power jumper across the PIN header on the battery pcb
located on the rear of the detector, shown below (Figure 2).
The unit is powered by 6 x Duracell AA MN1500 LR6 Alkaline Batteries. These are supplied fitted.
Should batteries require replacement please ensure they are inserted to the correct polarity as
shown below in Figure 2. Batteries that have been removed must be disposed of in accordance
with your country's relevant Waste Electrical and Electronic Equipment (W.E.E.E) regulations.
Figure 2
Power Jumper
Please see commissioning manual for log on procedure details.
To reassemble the unit, place the detector and head section into the fixed ceiling mount (ensuring
that locating lugs line up) and turn clockwise to achieve a positive location.
Ensure that the tamper switch operates correctly.
The switch should make contact with the
ceiling mount plate.
On detectors insert Allen key and turn clockwise to lock detector onto mounting plate if required
as shown in Figure 3.
Allen key slot
LED Position
Figure 3
EMS Group Head Office, Technology House, Sea Street, Herne Bay, Kent CT6 8JZ, England
Tel: +44 (0) 1227 369570 Fax: +44 (0) 1227 369679 Email:
enquiries@emsgroup.co.uk
Website:
www.emsgroup.co.uk
FireCell Radio Detector Installation Guide (Iss 7)
Page 2
Advertisement
