Craftsman 37634 Owner's Manual page 13

FOR OPERATOR SAFETY, keep fingers a ndallforeign
objects o utoftheintake ports. The rotating faninside
theblower housing isaccessible through t heintake
ports andishazardous. Donotwear l oose clothing o r
jewelry. Make certain t hateach intake p ort w hich isnot
being used orattached toa dust c ollection system is
covered w ithanintake p ort c ap.
CONNECTING TOOL TO
POWER SOURCE
A separate electrical circuit should be used for your
tools. This circuit should not be less than #14 A. W. G.
wire and should be protected with a 15-amp time lag
fuse. Have a qualified electrician repair or replace dam-
aged or worn cord immediately. Before connecting the
motor to the power line, make certain the switch is in
the "OFF" position and be sure that the electric current
is of the same characteristics as stamped on the motor
nameplate. All line connections should make good con-
tact. Running on low voltage will damage the motor.
DO NOT EXPOSE THE DUST COLLECTOR TO RAIN
OR OPERATE THE MACHINE IN DAMP LOCATIONS.
ON/OFF SWITCH
Fig. 10 A
/
\°
The ON/OFF switch assembly is located on the side of
the motor. To turn the dust collector "ON", move the
switch (A) up to the "ON" position. To turn the dust
collector "OFF", move the same switch down to the
"OFF" position. See figure 10.
LOCKING SWITCH IN THE
"OFF" POSITION
When the Dust Collector is not in use, the switch key
(B) should be removed so that it cannot be started.
Grasp the switch key and pull it out of the switch
assembly. With the switch key removed, the switch
will not operate. However, should the switch key be
removed while the dust collector is running, it can be
turned "OFF", but cannot be restarted without inserting
the switch key. See figure 10.
13