Product Description ENGLISH 1. Product Description Led Lighting Equipment suitable for medium and large industrial machine tools. Anodized Aluminium Structure and aluminium colour Varnished side plates. 5 mm Tempered Glass Protection High power Led light Source ...
Install and use the product only if in perfect Risk of explosion conditions. Risk of explosion might occur if this CCEA refuses product is installed and use into responsibility case applications with high risk tampering or wrong use of explosion.
Page 5
ENGLISH Safety Warnings Do not install and use this Danger caused by no-appropriate product where can be risk of Spare parts. explosion. Non appropriate spare parts may cause personal injuries and damages Installation and safety to objects. Handle with care and Avoid that ...
ENGLISH Levels of risk Do not try to repair or take the device apart. Turn to qualified personnel as for technical fault. Product tampering modification that have approved by the manufacturer will let warranty decline . 2.3 Levels of risk DANGER Danger that...
ENGLISH Versions 3. Versions In order to install and use the lighting system correctly and efficiently, look at the table below so as to clearly identify the right chosen item and verify its features. 4. Versioni disponibili Note: Product code is found on the label be stuck to the device. Find the product code printed on the label be stuck to the device;...
ENGLISH Guide to installation 5. Guide to Installation 4.1 Product sizes and accessories 24VDC Versions 19,5W 53,5W 4.2 Fixing ALPHA.CLIP Clip Fastening for rear adjustment 30° rotation ALPHA.ADP daptor for side to side adjustment 100° rotation...
ENGLISH Installation making sure that it is perfectly 4.3 Installation balanced (see 4.1) ATTENTION The lamp fall-down may cause injuries and damages to objects In order to install the lamp use only original fastening parts purchasable from the supplier. Install accurately the fastening ...
Page 10
Installation ENGLISH Side Fastening 6.1 Adjust lamp Flow light position up Correct installation using to 100° rotating the lamp on its ALPHA.CLIP along with ALPHA.ADP lengthwise axis. ALPHA.ADP is an aluminium Adaptor for side adjustment 100° lamp rotation tighten by an M6 screw. 1.1 Bore machine surface...
ENGLISH Collegamento elettrico Plug-in Lamp connector Male M12 4 Poles ADVICE Damaging or broken lighting. The product be damaged or be broken because of fall. During maintenance, operations do not completely untighten M6 screws. The lamp may fall down. Picture 5.1.1 ...
Cleaning operations must be correctly carried out. done only after the power supply has been turned off and the If the lamp is faulty Contact CCEA TECHNICAL surfaces have been cooled down. SUPPORT Afterwards the surfaces of the...
11. Warranty charged according with CCEA Srl rates. TERMS OF WARRANTY 12. Waste Disposal During the Product lifetime, the CCEA Warranty of the purchased product...
Power Supply 220-240V 50/60Hz Power 19,5-34-53,5W (See Label) IEC Class Degree of protection IP67 LED Driver CCEA IDS Integrated Driver System Light Colour 5000K Operating Temperature -20 + 55 °C See Table page 7 for Further Technical data...
C.C.E.A. SRL, via Piave, 2 - 36077 Altavilla Vicentina (VI) - P.I. e C.F. 02374040240 hereby declares that the light equipment item TRACKALPHA it has been manufactured by CCEA SRL to which this declaration relates is in accordance with the following Directives: 2006/95/EC on Low Voltage Equipment Safety and the Directive of Electromagnetic Compatibility 89/336/CEE (EMC) 2004/108/EC.