Table of Contents
Advertisement
All manuals and user guides at all-guides.com
CLT9960 3rd
7/12/00
6:49 PM
GETTING
Handset retainer
Note:
When the belt clip is attached onto
the handset, you can hang the
handset on the wall-mounted base
with the keypad facing inside only.
Direct wall-mounting
If you do not have a standard wall plate, you can still mount your phone directly to the
wall. Before doing this, consider the following:
• Avoid electrical cables, pipes, or other items behind the mounting location, that could
cause a hazard when inserting screws into the wall.
• Try to mount your phone within 10 –15 feet (3 – 4.5 m) of a working phone jack to
avoid excessive cord lengths.
• Make sure the wall material is capable of supporting the weight of the base and
handset.
#
• Use
10 screws with anchoring devices suitable for the wall material where the base
unit will be placed.
TOP
3/16 in.
(4.8 mm)
3-15/16 in.
(100 mm)
E8
Page 12
STARTED
8
On the base unit, pull the handset retainer out
of the slot. Rotate it clockwise 180 degrees.
9
Flip the retainer. Slide it back into the slot so
that the lip of the retainer is up and the
points down. The retainer holds the handset in
place.
1
Insert two mounting screws with a minimum length
of 1-3/8 inches (35.5 mm) into the wall, 3-15/16
inches (100 mm) apart. Allow about 3/16 of an
inch (4.8 mm) between the wall and screwheads
for mounting the phone.
2
Refer to steps 1 through 9 on pages 7 and 8 to
mount the telephone.
Advertisement
Table of Contents
