Table of Contents
Advertisement
SETUP - Signal
The Signal Display
On the Signal display you can select the main inputs, Insert send and return, Sample Rate source, ADAT or TOS Link
output, and view what outputs are available.
To get to the Signal page press the SETUP button, if you are not already there, and use the < > Menu keys to select SIGNAL.
Basic operation is accomplished by using the Parameter wheel to change cursor position and the value wheel to change values.
Input Source
on Channel 1
and 2
External Clock
indicator
The Signal Display
Whenever you touch one of the Input selectors on the front, the
Signal display will pop up, and disappear after a few seconds. If
you don't want the display to go back automatically, you can set
the Auto Pages parameter in the Utility/Config display to OFF.
NOTE: This will also affect the Gain display.
Input
The Input box is controlled from the Input selector for each
channel on the front. It can be Mic, Line or Digital input. If it's
set to Digital, the Value wheel is used to select between the
different digital formats: AES/EBU, S/PDIF, TOS Link and
ADAT. You cannot select different digital formats for channels 1
and 2.
NOTE: The Input select overrides the Insert send/return, meaning
that the setting selected at the Input cannot be chosen at the
Insert return. Also note that the Insert option is only available
when both channels are either analog or digital. You will get the
message: INSERT OFF, if the insert is no longer possible, and
INSERT ON when it's possible again.
14
Select Insert Send and
Return sources
Sample rate source
"Signal" page selected
Select Dither for
the digital outputs
AES/EBU - Digital AES/EBU can use up to 24 bits. Use the
balanced XLR Digital In/Out for this connection. AES/EBU
should use balanced 110 Ohm cables. The incoming sample rate
will be displayed in the Digital box at the Signal page. The
"Digital" LED's will be blinking if no clock is present or if the
Gold Channel cannot lock to the incoming clock.
S/PDIF - Digital S/PDIF can use up to 20 bits. Use the RCA
jacks In/Out for this connection. S/PDIF should use unbalanced
75 Ohm cables. The incoming sample rate will be displayed in
the Digital box in the Signal page. The "Digital" LED's will be
blinking if no clock is present or if the Gold Channel cannot lock
to the incoming clock.
TOS link - Optical TOS link uses the S/PDIF digital format. Use
the Optical In/Out for this connection. TOS link uses fiberoptic
cables. The incoming sample rate will be displayed in the Digital
box at the Signal page. The "Digital" LED's will be blinking if
no clock is present or if the Gold Channel cannot lock to the
incoming clock.
Signal is present on all
shown outputs.
Select Channel Status
Bits output
Select between
ADAT, TOS or
THRU for the
optical output
Hide quick links:
Advertisement
Table of Contents
