Related Manuals for Strong Carbon Series
Summary of Contents for Strong Carbon Series
-
Page 1: Installation Manual
SM-CB-ART2-L Strong™ Carbon Series Universal Articulating Mount With Dual Arms INSTALLATION MANUAL... - Page 2 The maximum supported weight of this wall mount is 150 lbs (68.04 kg). Use with heavier CAUTION than the maximum weight indicated may result in instability causing possible injury. Le poids maximum de ce support mural est de 68 kg (150 lbs). L’utilisation avec un poids ATTENTION plus haut que le poids maximum indiqué...
- Page 3 HARDWARE IMAGE DESCRIPTION ITEM QUANTITY BAG 1 Lag Bolt (A) 8 × 63 mm Lag Washer (B) 8.4 × 19 × 2 mm Concrete Anchor (C) 10 × 50 mm Screw (D) M6 × 20 mm Screw (E) M6 × 40 mm Screw (F) M8 ×...
-
Page 4: Installation
INSTALLATION Layout and Drilling Determine general location of the display. Use a stud finder to find the nearest wall studs if applicable and mark their location. NOTE: Stud sizes must be a minimum of 2"x4" and covered with no more than 3/8" thick dry wall. Tape template flat and level to wall surface, aligning the template’s slots with the stud markings on the wall. - Page 5 Assemble Display Bracket Slide the fixed TV brackets onto each end of the Horizontal Mounting Bars (Figure 2). Horizontal Mounting Bars Fixed TV Bracket Bolts (pre-installed) Adapter Plate Figure 2 Mount Display Bracket to Display Panel Place the assembled Display Bracket on the back of the display with one Adapter Bracket aligned with a set of vertical mounting holes (Figure 3).
- Page 6 Attach Screen to Arm Assembly Remove pre-installed hex nuts and nylon washers from bottom bolts on adapter plate using the provided socket wrench (N). Lift the display and hook the two pre-installed bolts in grooves on top of the Mounting Head (Figure 4). Insert bottom two bolts (where hex nuts were previously installed) in bottom two holes of the Mounting Head.
-
Page 7: Tilt Adjustment
ADJUSTMENTS Tilt Adjustment Using the provided socket wrench (N), loosen tilt lock bolts each side of mount head (only enough to allow controlled adjustment) (Figure 6). Adjust tilt. Tighten locking Tilt Levers. NOTE: Once the tilt levers are locked, the position of the levers can be adjusted without loosening or tightening the unit by pulling the levers outward and then repositioning them to a vertical, less obtrusive position. -
Page 8: Contacting Technical Support
Phone: (866) 838-5052 Email: techsupport@snapav.com LIFETIME LIMITED WARRANTY Strong™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective in material or workmanship under normal conditions of Lifetime use. This warranty shall not apply to products which have been abused, modified or disassembled.